Odontoid processes11/24/2023 ![]() Surgery may be used in severe cases, and may have good outcomes. Conservative management is usually effective, involving analgesics. This involves classic pathophysiology, such as loss of articular cartilage, osteophytes visible with radiography, and bone thickening with a narrow joint space. Osteoarthritis may occur at the atlanto-axial joint. Posterior atlanto-occipital membrane: genetic traits can sometimes result in ossification, turning the groove into a foramen. If it reaches the medulla death can result.Īlar ligaments: stress or trauma can stretch the weaker alar ligaments, causing an increase in range of motion of approximately 30%. Transverse ligament: Should the transverse ligament of the atlas fail due to trauma or disease, the dens is no longer anchored and can travel up the cervical spine, causing paralysis. The dens itself is vulnerable to fracture due to trauma or ossification. The dens: significant depression on the skull can push the dens into the brainstem, causing death. Common trauma and pathologies include (but are not limited to): The atlantoaxial articular capsules are thick and loose, and connect the margins of the lateral masses of the atlas with those of the posterior articular surfaces of the axis.Įach is strengthened at its posterior and medial part by an accessory ligament, which is attached below to the body of the axis near the base of the odontoid process, and above to the lateral mass of the atlas near the transverse ligament.īecause of its proximity to the brain stem and importance in stabilization, fracture or injury to the atlanto-axial joint can cause serious problems. The ligaments connecting these bones are: Between the articular processes of the two bones there is on either side an arthrodial or gliding joint. The lateral atlantoaxial joint involves the lateral mass of atlas and axis.one between the anterior surface of the ligament and the back of the odontoid process.one between the posterior surface of the anterior arch of atlas and the front of the odontoid process.The median atlanto-axial joint is sometimes considered a triple joint:. ![]() There are three atlanto-axial joints: one median and two lateral: There is a pivot articulation between the odontoid process of the axis and the ring formed by the anterior arch and the transverse ligament of the atlas. The atlanto-axial joint is a joint between the atlas bone and the axis bone, which are the first and second cervical vertebrae. ![]() The atlanto-axial joint is a joint in the upper part of the neck between the atlas bone and the axis bone, which are the first and second cervical vertebrae. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |